Charnwood C4 Instrukcje Operacyjne Pobierz pdf (Strona 13)

INSTALLATION INSTRUCTIONS

Warm air

Optional air ducts

can carry heat

to other rooms

Rear outlet of stove

Flexible tube

ø80mm

Air supply

Flue

Air supply duct must be fitted

to bring cool air into the stove.

This could be through an external

wall, from another room, or

from the same room as the stove.

PREPARATION OF FIREPLACE

If the fireplace contains combustible materials, inlet and outlet air

vents with an area of 246cm² each must be fitted below and above

the stove convection case to provide a continual air flow around the

stove. It is recommended that Calcium Silicate board is used

(130mm board, with a 100mm air gap between the stove and the

insulation (see Fig. 12).

If the fireplace does not contain combustible materials, it is still

recommended to have a layer of insulation or ventilate the space

between the casing and the outer wall. The insulation may consist of

a layer of mineral fibre or calcium silicate board. Insert this into the

opening before sliding in the convection casing.

The air supply inlet can be fitted in the room or outside, in

accordance with the requirements in 'Air Supply' section (p11). The

inlet grille must not constrict the airflow through the duct and it

must be permanently open. A semi rigid aluminium flexible duct of

no less than 80mm diameter is used to bring the air to the stove .

The duct must be less than 5.5m long, have no more than five 90º

bends and two 45º elbows. The 80mm diameter spigot, provided

with the stove should be fitted on the outside of the convection case,

using two self tapping screws and the duct should be terminated on

the spigot with a jubilee clip. The 100mm diameter spigot provided

should be fitted to the inside of the convection case using two nuts

on the outside and the self adhesive foam should be glued into

position around the circumference of the inside of the 80mm spigot

in order to seal against the spigot on the back of the stove when it is

installed.

Before fitting the appliance into an existing fireplace remove the

fireback and any loose in-fill material.

The surround and opening for the appliance must conform with

Fig.11. The flat area around the opening should be a minimum of

500mm wide and 600mm high. Ensure that the hearth and the base

in the opening are flat, level, and at right angles to the surround.

Fig. 13 Installation in standard chimney

Fig. 14 Air Supply

Flue

Flue collar

External air kit

to outside wall

Closure plate

100mm air gap must be ventilated with inlet

and outlet apertures of minimum 246cm²

Top of stove

Non Combustible

Calcium

silicate board

130mm

Fig. 12 Fireplace With Combustible Material

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Komentarze do niniejszej Instrukcji

Brak uwag

Charnwood C4 Instrukcje Operacyjne Strona 13

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Kuchenki Charnwood C4