Charnwood W721 Instrukcje Operacyjne Pobierz pdf (Strona 12)

Release the belt tension by turning the

tension control handle on the front of the

lower housing. Move the belt from the larger

pulley to the smaller one and then from the

smaller to the larger on the other pair.

Always have the drive belt on one large and

one small pulley.

This bandsaw is equipped with a cross

cut/mitre fence which can be fitted as shown.

The fence is equipped with adjustable stops

for 45° and 90° cuts.

The rip fence is reversible and may be used

on either side of the blade.

Your bandsaw is now ready for use but it is recommended that a suitable dust extractor is

connected before use.

Changing the Blade

Bandsaw blades are sharp enough to cause injury even when too blunt to cut wood! It is

recommended that protective gloves be worn when handling blades.

Unplug the bandsaw from the mains socket, slacken off the blade tension and open the

upper and lower housing doors. Although there are two micro-switches which will prevent

the saw from being started with a door open, disconnection is a good habit to develop.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Brak uwag

Charnwood W721 Instrukcje Operacyjne Strona 12