Charnwood W715 Instrukcje Operacyjne Strona 1

10” BANDSAWOPERATING INSTRUCTIONSMODEL: W715Charnwood, Cedar Court, Walker Road, Bardon,Leicestershire, LE67 1TU Tel. 01530 516926 Fax. 01530 516929

10 This bandsaw is equipped with a rip fence and a cross cut/mitre fence which can be fitted as shown. The rip fence may be used on either side

11 Lower the upper blade guide Remove the rip fence carrier (shown here still in place) Slide blade off upper and lower wh

12 Parts List Item Description Quantity 1 Slotted Insert 3 2 Washer 3 3 Housing 3 4 Washer 3 5 Lower Door 1 6 Housing, with nut 3 7 Tongue 3 8 Ex

13 49 Lower trunnion 1 50 Washer 1 51 Cap head screw 3 52 Thrust bearing retaining block 1 53 Guide pin 2 54 Thrust bearing shaft 4 55 Thrust bearin

14 102 Spring washer 4 103 Motor mounting plate 1 104 Motor 1 105 Motor cable 1 106 Mains cable 1 107 Nut 2 108 Hex head bolt 4 109 Strain relief 2

15

Charnwood, Cedar Court, Walker Road, Bardon,Leicestershire, LE67 1TU Tel. 01530 516926 Fax. 01530 516929email; [email protected] website; www.cha

2 GENERAL SAFETY RULES WARNING: Do not attempt to operate the machine until you have thoroughly read and understood completely all instructions,

3 17. Never leave the machine running unattended. Turn the power off. Do not leave the machine until it comes to a complete stop. 18. Do not use

4 Specification Table size 340 x 335 mm Motor 370W Blade length 1712 mm Blade speed (no load) Blade widths 1400±10% m/min 6 to 12 mm Maximum

5 Unpacking Cut the strapping and remove the carton from the polystyrene insert. Remove all parts from the packaging Assembly Place

6 Screw the four hex, headed bolts and washers into the tapped holes on the underside of the table and slide the rip fence carrier on to them.

7 The lower trunnion is attached to the body of the saw by four hex headed bolts. These may be slackened and the trunnion slid in either directio

8 Screw in and lock the push stick hanger on the back of the frame. This completes the assembly of your saw. Setting up your saw Blade t

9 The upper and lower thrust bearings and guide pins should be set up next. Thrust bearing Guide pin Guide pin locking screw Thrust bearing loc